How to make a PVC Sand Spike for sand

Sand Spikes or Rod Holders for loose sand areas are made from PVC Pipe. A single 6 foot length of 2 inch diameter PVC pipe will make two 3 foot long sand spikes. Use schedule 40 PVC which is heavier than light weight PVC. Cut the PVC pipe on about a 30 degree angle as shown in the picture below. Then sand the cut area and opposite ends with sandpaper to remove any sharp edges. The PVC Rod Holder can easily be pushed into loose sand and will support a fishing rod.

For more information, fishing tips, tactics and techniques about Surf, Shore and Harbor fishing Click here to visit our Shore Fishing Tips section

Great Lakes Salmon, Steelhead, Trout and other species Fishing tips, tactics, articles, techniques, and information
General Fishing Tips	Shore, Surf and Harbor Fishing	Ice Fishing
Tributary River and Stream Fishing	Open Water Boat Fishing and Trolling	Coming Spring 2010 Small Boat and Watercraft Fishing
For more information click a topic category above